Zebra scanner support number serial#
Zebra scanner support number manual#
Zebra scanner support number android#
Zebra scanner support number Bluetooth#

However, to configure decoders, reader parameters and other scanner settings, a Bluetooth scanner must be connected.

After initial configuration, a Bluetooth scanner can be enabled and disabled in the Profile, even if it is disconnected from the device.

To initially configure the RS507 in a Profile, the scanner must be paired and connected.

Zebra scanner support number android#

Note: Use of multiple scanners with multiple Android user accounts may result to unexpected behavior.ĭataWedge supports the following Zebra Bluetooth scanners:īluetooth scanners are supported according to the following rules: If an attempt is made to assign a trigger that is already assigned to a different scanner category, the following message is displayed: If an external scanner is removed from the scanner selection, the internal scanner is given all the triggers again.

Once a trigger or multiple triggers are assigned to the external scanner, those triggers are removed from the internal scanner. The user needs to select the triggers for the external scanner as required. If an external scanner and an internal scanner is selected (regardless of the order added), the internal scanner is given all the triggers by default.

Tap on Configure Triggers to display a list of triggers to configure the options vary depending on the device in use. Long pressing on the scanner category in the Scanner Selection screen displays a menu with options to Configure triggers or Delete. If Scanner selection is set to Auto, all scanners are removed from the list. The selected scanner is then added to the Scanner Selection list. A list of available scanners is displayed. To add a scanner, in the Scanner Selection screen tap the top right menu and select Add new scanner. Additionally, each scanner can be individually configured within the same profile.

Zebra scanner support number manual#

Multiple scanner support provides the capability to use more than one scanner interchangeably in the same DataWedge profile without the need for manual configuration, such as when an internal scanner and an external Bluetooth scanner is required. When 2D Imager is selected, scanning is performed using the installed Scan or Scan/MSR module.When the camera is selected, scanning is performed with the rear-facing camera.If no Scan Module is installed, the camera is selected.If a Zebra Scan Module or Scan/MSR Module is installed, the 2D imager is selected.'Auto' is the default scanner selection, automatically determining the best scanning device from the list of available devices based on the following Auto Scanner Selection Rules: The list of available scanners is based on devices present in (or connected to) the unit being configured. In Barcode Input, the Scanner selection panel determines which scanning device to use for data capture.

The parameters of this feature can be configured using the Set Config API. The raw barcode data that's acquired is processed or formatted as using the Basic and Advanced Data Formatting Processing options that are found near the Output options. DataWedge supports lasers, imagers and internal cameras.

Zebra scanner support number serial#

USB synchronous serial interface (SSI) scannersīarcode Scanner Input reads data from the integrated barcode scanner built into the device, or attached via cable or Bluetooth connection, or implemented as a snap-on module.

See the Scanner Parameters section for more information. DataWedge also provides audio and other feedback to alert the user of scanning results and barcode type. Decoders supported by DataWedge are explained below, including commonly used decoders: Code39, Code128, Datamatrix, DotCode, EAN13, OCR A, OCR B, PDF417, QRCode, UPCA, and UPCE. Barcode Input options within the DataWedge profile specify the device hardware to use for scanning and the decoders to be applied on the acquired data before sending it for processing.